Embedded LPC3250 Guide de l'utilisateur télécharger pdf (Page 31)

LPC3250 Developer’s Kit v2 - User’s Guide

Page 31

4.18 SP10: CAN

The CAN interface is not supported since there is no on-chip CAN peripheral on the LPC3250.

For reference, the information about the interface is described below.

There is one CAN interface mounted on the board. The board is also prepared for a second CAN

interface, if needed. Via JP16 it is also possible to add termination resistors, if needed. The interface

has on-board ESD protection.

See picture below for locating relevant components. The table below lists signal connections.

Figure 17 – CAN Interface

Signals

LPC3250

GPIO14_CANRD

U6_IRTX. Note: not a CAN interface

GPIO15_CANTD

U6_IRRX. Note: not a CAN interface

GPIO18_CANRD

GPO_02. Note: not a CAN interface

GPIO19_CANTD

GPO_03. Note: not a CAN interface

CAN part of Connector

J16

From top (pos 6)-to-bottom:

GND

CAN1-L

CAN1-H

CAN2-L

CAL2-H

Termination Resistors Control

JP14

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 65 66

Pas de commentaire

Embedded LPC3250 Guide de l'utilisateur Page 31